![]() I have been surviving with a regular drill bit for most of my DIY work. Set comes with a blow-molded carrying case with handle for easy transportation and secure storage.Intended usage for professionals and serious DIY enthusiasts for a broad range of masonry and percussion application.Compatible for use with for most standard SDS or SDS-Plus hammer drills works with BOSCH, HILTI, MAKITA, and more.Heat-treated alloy steel drill bits run cooler, drill smoother and last longer than standard bits.C2 tungsten carbide tipped hammer drill bits for faster penetration with less pressure.Ideal for a variety of demolition and masonry application on concrete and other materials. ![]() In German-speaking countries, the back-formation "Spannen durch System" (Clamping System) is used, though Bosch uses "Special Direct System" for international purposes. The name comes from the German "Stecken – Drehen – Sichern" (Insert – Twist – Secure). The SDS bit was developed by Hilti and Bosch in 1975. Hilti's TE-S system is similar to these SDS systems, but is designed for chipping only (no rotation) in tools for applications larger than could be handled by SDS-Max (e.g. SDS-Top has been largely phased out in North America and is not common except for older tools. ![]() Standard lengths are 12 to 21 inches (300 to 530 mm). SDS-max is more common for larger rotary hammers and chipping guns, and common sizes start at 1⁄2 inch (13 mm) diameter up to 1 3⁄4 inches (44 mm) diameter. The shortest SDS-plus masonry drill bits are about 110 mm overall length, and the longest 1500 mm. SDS-plus is the most common by count of tools manufactured, with masonry drills from 4 mm diameter to 30 mm (and from 5/32" to 1-1/4") diameter ordinarily available. ![]() There are three standard sizes of SDS: SDS-plus (or SDSplus or SDS+), SDS-Top and SDS-max. The shank must be lubricated with grease to allow it to slide in the chuck. ![]() The hammer of the drill hits the flat end of the shank. The smaller indentations that do not open to the end are grasped by the chuck to prevent the drill bit falling out. The rotational drive uses the sliding keyways that open to the end of the shank, which mate with keys in the chuck. The hammer of the drill acts to accelerate only the drill bit itself, and not the large mass of the chuck, which makes hammer drilling with an SDS shank drill bit much more productive than with other types of shank. The drill bit is not held solidly in the chuck, but can slide back and forth like a piston it does not slip during rotation due to the non-circular shank cross-section, matching the chuck. This shank and chucks made for it are especially suited to hammer drilling with masonry drills in stone and concrete. The SDS shank has the advantage of fitting into a simple spring-loaded chuck, so that bits are simply pushed into the chuck without tightening. The diameter of an SDS and SDS Plus shank is 10 millimeters. What are the differences between SDS, SDS Plus, and SDS Max drills? ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |